Techniseal

Slurry Remover

4 Liters

Quantity :

Removes cement slurry and polymeric sand haze on bare surfaces such as concrete or clay pavers and slabs.

Type of surface :
Concrete Pavers - Concrete Slabs - Self-locking Pavers

Special order only

Keep out of reach of children

STORAGE
Store in original container protected from direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials and food and drink.

COVERAGE
4 liters of concentrated product clean up to 600 square feet. Coverage will depend on surface condition and product dilution.

PACKAGING
Size : 4 liters and 18.93 liters
4 units per box of 4 liters

Read the Material Safety Data Sheet before using this product. Wear acid-resistant clothing, boots, gloves and safety goggles.

Dilution :
Principle : To use the strongest concentration of product without etching or discolouring pavers. A weaker concentration will increase the labor factor.
1. Into a plastic watering can dilute 1 part product in 8 or more parts water.
2. Test the concentration on spare pavers or on a small hidden area of approximately 4 sq. ft.. Test area or spare pavers must be wet.

If the product etches or discolours the pavers: lower the concentration (1 part product in 10 parts water) until the product no longer etches or discolour the pavers.

If the product DOES NOT etch or discolours the pavers: to increase product efficiency and reduce scrubbing, you may use a stronger concentration. The concentration must be strong enough to remove slurry without etching or discolouring pavers.

IMPORTANT : Always test diluted product before using on the entire surface.
ALWAYS POUR THE SLURRY REMOVER INTO WATER; NEVER POUR WATER INTO THE PRODUCT.

Wetting :
To prevent product penetration and make rinsing easier, first saturate surface with water. Always work on a wet surface.

Application : Do not use on flagstone or on natural stone. 

Cement slurry on concrete pavers or slabs :

1. If application is done on pavers with new polymeric sand joints, wait 30 days before applying the product.
2. Using a plastic watering can, cover the cement slurry with SLURRY REMOVER. Work in small areas.
3. Lightly scrub.
4. Rinse immediately and thoroughly.
Product should not sit on the surface more than a few seconds.

Polymeric sand haze on concrete pavers or slabs :
1. If application is done on pavers with new polymeric sand joints, wait 30 days before applying the product.
2. Work in small sections; no more than 50 sq. ft..
3. Using a plastic watering can, cover the area with SLURRY REMOVER.
4. Lightly scrub.
5. Rinse immediately and thoroughly.
6. Move on to the next section.
Product should not sit on the surface more than a few seconds.

IMPORTANT : DO NOT let product dry on the surface. If product dries on the surface, reapply product, lightly scrub and rinse immediately and thoroughly.

TIP :
To improve efficiency on large areas, 3 persons are recommended to apply the product. One person should spray (pour) the product while another is scrubbing and a third is rinsing.

Dirt & Grease Cleaner
Dirt & Grease Cleaner
1 Liter
Organic Stain Remover
Organic Stain Remover
700 grams
Information