Techniseal

Paver Restorer

4 Liters

Quantity :

Techniseal® Paver Restorer removes the haze left after grout and masonry work on tiles and pavers made of concrete or clay. It works efficiently without discolouring or damaging the surface. Unlike muriatic acid, Techniseal® Paver Restorer releases very little odour and is environmentally friendly.

Type of surface :
Concrete Pavers - Concrete Slabs - Self-locking Pavers

Keep out of reach of children

COVERAGE
4 liters of product clean up to 200 square feet.
The coverage will depend on the severity of the haze.

STORAGE

Store in a cool and dry place, away from the sunlight and with adequate ventilation.

PACKAGING
Size : 4 liters - 18.93 liters
4 units per box of 4 liters

Before you begin
• Do not use on natural stone, wet-cast pavers and stamped or poured concrete.
• Wear rubber gloves and safety goggles.
ALWAYS TEST on a small hidden area of approximately 4 square feet to ensure that result meets your expectations
• Never use this product without first consulting with local authorities regarding the application of such products, waste management and run-offs.
• Do not apply under blazing sun.
• Protect people, vehicles, property, vegetation, and other surfaces not set for cleaning from product, residue, splash, fumes and wind drift.

Preparation

Surface wetting :
To reduce the penetration of Paver Restorer into sand joints and thus make product easier to rinse, first wet the surface to saturate joints with water; then let the surface dry, and apply product.

Dilution :
Dilution must be adjusted according to the amount of haze present on the pavers. In a plastic container, dilute the product in water. Always pour the product in water, not the other way around. The recommended dilution ratio is 1 part product in 1 to 4 parts water, depending on the severity of the haze. Always test the dilution on a small area first, in order to clean the surface without damaging or discoloring the material. If haze persists, reapply product using the proper dilution.

Newly installed polymeric sand :
Wait at least 30 days before applying the product.

Application

Important :
Do not apply product with a mop or a broom. Never let the cleaning solution dry on the surface; keep it wet at all times until it is completely rinsed off. Never apply the product at full strength.
Clean one section of 200 square feet. at a time. On each section, starting from the bottom of the slope, cover surface with diluted solution, making sure to cover the whole section without leaving any dry spots. Next, gently scrub the surface using a street broom; rinse immediately and thoroughly, until all traces of foam disappear, before proceeding to another section. In cleaning each section, overlap the edges of adjoining sections to ensure that no uncleaned strips are left between them. Once all the sections have been cleaned, rinse thoroughly and let dry. If there is any haze left on the surface, repeat cleaning.

Organic Stain Remover
Organic Stain Remover
700 grams
HD Paver Prep
HD Paver Prep
4 Liters
Information