Removes most stains, sealants and coatings
Properties
• Removes most stains, sealants and coatings without affecting the surface
• Eco-friendly: Does not damage vegetation or substrate
• Turns into a powder or a thick paste once dry
• No water required
The ECO-STRIPPER is a cream that removes virtually all stains, sealants and coatings, which can be easily applied on horizontal and vertical surfaces. This green product does not affect the surface or vegetation. ECO-STRIPPER does not damage the substrate (paver, concrete, etc.) and emits a slight citrus scent.
Keep out of reach of children
Coverage :
18.93 liters strip up to 200 square feet depending on the need
Type of surface :
Concrete Paver, Concrete Slab
Storage :
Keep from freezing, store in a cool and dry place, in original container.
Packaging :
Size : 18.93 liters
BEFORE YOU BEGIN
Wear adequate protective clothing.
ALWAYS TEST To ensure the results will meet your expectations, always test product on a small hidden area of approximately 26 cm2 (4 sq. in.)
Do not thin or dilute.
This product might not work on certain type of coatings.
Do not use on asphalt.
Surface preparation
To allow a good contact between the ECO-STRIPPER and the product to be removed, surface should be free of any dry detritus or debris. Without using any water, sweep clean the surface from any dirt, sand, leaves, detritus or debris.
Application
Important : Surface and joints must be completely dry (24 hours without precipitation). Temperature should be between 10°C et 30°C. At a lower or higher temperature, the product’s effectiveness will be reduced. Rain or heavy dew should not be forecasted for the next 24 hours.
Stir product well before use.
Using a semi-soft bristle street broom, apply a generous amount of product on the surface. There must be enough product to make it completely opaque. Let sit for 8 to 24 hours. Product is dry when it turns from a liquid to a thick paste or powder. Once product has completely dried, sweep up with a broom and dispose of the residue using the ECO-STRIPPER container. Using a pressure washer (2000 to 2500 psi) with a recommended tip (do not use zero degree or rotating tips), rinse surface in order to completely remove ECO-STRIPPER residue. The use of hot water will make the stripping easier. Let surface dry. Repeat if necessary.
Note : Surface may still appear dark immediately after powder has been swept up; this is not remaining sealant, but rather a natural solvent trapped in the pores, which should evaporate within a few hours or days.
Cleaning & Disposal
Wash tools and hands with warm soapy water. Consult your retailer or municipality regarding the disposal of empty containers or unused product.
